Type HSG-GMN-V-E/N

The Standard model has a straight blade, suction with blower, protection cap and foot switch, quick change system for blade(s), plug in electric connections, heat transformer with separate temperature control.

While the blade is moved manually with the smaller tools, it is done at the blade-stand by means of a pneumatic cylinder.

The fabric is placed under the blade or combined tool and the cutting operation is released through hand or foot actuation. Then the fabric is pulled on forward to the desired length-measure to be controlled with tape measure or adjustable limit Stop. With the following cut the firstsection is trimmed on both ends while the first edge of the next section is trimmed. This means, with each cycle, one section is completely trimmed.

Movement of the blade(s):| |Pneumatic.

Belt width:| |60 - 150 - 250 mm.

Belt thicknesses:| |Max. 5mm

Rope diameter:| |Max. 20mm Ø

Cutting element:| |Electric direct heated blade. Heating time in approx. 1 minute to 600°C.

Temperature:| |100 - 600°C, infinitely variable.

Voltage:| |230 Volt - 50/60Hz (110Volt -60Hz)

Power input:| |800 VA depending on type.

Air pressure:| |6 bar

Dimensions:| |approx. 300 x 400 x 300 mm (b x h x t)

Weight:| |approx. 30 kg, with heating transformer; depending on type.

Datasheet

cuts can be assemble in a kind of combined tools:

- Diagonal cuts.

- Shaped cuts.

- Perforation cuts.

- Pressing device.

- Swivel device for alternative right/diagonal with adjustable
  cutting-angle.